![](//blog.wenxuecity.com/images/pixel_trans.gif) |
1. Disconnect the negative cable from the battery; 2. Mark the location of each wire, then take ignition wires off the distributor cap. Accord engine fire order is 1,3,4,2.
![](https://lh4.googleusercontent.com/-2_xqNtVBfn8/T1bNQY5rZAI/AAAAAAAAAOs/bfq95YOORxI/s1071/P1080927.JPG)
3. Rotate engine from this hole by using 19mm socket.
![](https://lh6.googleusercontent.com/-piZM1tdDWIY/T1bNQdIJl0I/AAAAAAAAAOw/RSEf3OfFS4c/s1071/P1080928.JPG)
4. Get the piston in the No. 1 cylinder to the Top Dead Center (TDC) spot.
![](https://lh4.googleusercontent.com/-jx7dfO854WY/T1dIparhmUI/AAAAAAAAAPI/6OsfEYtdAJY/s1071/P1080930.JPG)
5. Make sure rotor is pointing to No. 1 cylinder cable position.
![](https://lh5.googleusercontent.com/-tj4dyW_XeKg/T1bEOdcOFxI/AAAAAAAAAOQ/CmIwIT2-1JU/s1071/P1080931.JPG)
6. Make the marks between distributor housing and engine block.
![](https://lh5.googleusercontent.com/-gGXvpvr9rx8/T1bEa72fIDI/AAAAAAAAAOY/UN9U8pDhRiQ/s803/P1080932.JPG)
![](https://lh6.googleusercontent.com/-DGqWtPaWMWA/T1bEbDXOrnI/AAAAAAAAAOg/ifsiCZ3IdUc/s803/P1080933.JPG)
7. Carefully take distributor out from the engine. O ring seems leaking long time.
![](https://lh3.googleusercontent.com/-hd5G17M-Yyk/T1bEIk6N9vI/AAAAAAAAAOA/e6EakyYF7tc/s1071/P1080936.JPG)
![](https://lh3.googleusercontent.com/-dsKEYRbRCEU/T1bEIgGkT_I/AAAAAAAAAOE/I998Cn-5D_g/s1071/P1080937.JPG)
10. Clean the parts and install the new o ring to the distributor and the install the distributor to the engine. Make sure the marks are alignment up.
11. Connect all wires and cables and you are done !
|
![](//blog.wenxuecity.com/images/pixel_trans.gif) |
|